Anaa is a growth hormone that helps plants grow. It is a chemical that stimulates root growth and increases the growth of the roots, It is available in powdered and liquid form. Anaa growth hormone is applied to plants and planting materials like seeds and cuttings before planting them; in addition to being effective, it is also safe for flowering plants. While it has many uses, it is the most common is to promote the development of roots.

Uses of ANAA Plant Growth Hormone

You can use ANAA rooting hormone on plantlets, marcots, transplants, cuttings, seeds, bare roots, seeds, and whole plants. The application method and procedure for each plant matter differ; you must ensure you apply this rooting hormone correctly to get the desired result.

To use ANAA rooting hormone on plantlets, marcots, and transplants, mix 1 tablespoon of ANAA plant growth hormone in one gallon of water. Spray the Anaa hormone solution on the plants every 5 days till the plant is fully grown. The hormone stimulates and encourages better root and foliage development to encourage rapid growth of the plant.

When you want to use Anaa rooting hormone on cuttings, either root, leaf, or stem cuttings, mix 2 tablespoons of Anaa rooting hormone in 1 gallon of water. Soak the cuttings in the hormone solution for 12 hours before planting. Before soaking, ensure the cut off the top leaves from the cuttings and slightly bruise it before soaking, this allows better penetration of the hormone into the vascular system of the cuttings.

After soaking the cutting within the stipulated time, plant the cutting in potted soil and place the pot in partial shade avoiding direct sunlight; the cuttings should be in a position where they can receive maximum light. The plant should start sprouting roots after about 5 – 7 days. Always make sure that the roots are strong and healthy before transplanting, otherwise, it can wilt and kill your plants.

You can apply ANAA growth hormone on established plants for rapid root development and growth; mix 2 tablespoons of Anaa rooting hormone in a gallon of water; spray the solution on the intended plant every week. The plants that you can apply Anaa rooting hormone on are vegetables like orchids, lettuce, cabbage, flowering plants, eggplants, watermelon, potato, kale, etc.; fruit crops like citrus, and mango, can also benefit from the rooting action of Anaa rooting hormone.

Precautions for Using Anaa Growth Hormone

To increase the effectiveness of Anaa growth hormone, you need to follow some precautions that enable the right usage of the rooting hormone to achieve the best results; these precautions include:

• When you take a cutting, you should cut it at an angle of 45 degrees
• You should thoroughly wash the cutting with water to remove any residue and avoid contamination.
• Ensure you cut all foliage present on the cuttings before soaking
• Do not forget to slightly bruise the cuttings before soaking in the rooting hormone, it allows penetration of the hormones into the cutting system
• It is recommended that cuttings be started in potting soil to monitor the growth rate and give intensive care.
• Always use the right mixing ratio or dosage of the Anaa rooting hormone and water before applying, The correct dose is the key to success.
• Ensure that your plant is healthy before transplanting it. Doing so will help reduce the chances of crop failure.

In summary, Anaa plant growth hormone is a widely used plant rooting hormone. You can apply this hormone to existing plants and cuttings of flowering plants. You should be sure to apply the correct dosage to the cuttings because too much will cause the plant to wither or yellow. One important thing to remember is to follow the instructions to the letter. Using too much or too little hormone can cause problems. You can get it online or at a garden center. You can use honey as a substitute for ANAA rooting hormone.